[ SECRET POST #6366 ]

[case]

⌈ Secret Post #6366 ⌋

Warning: Some secrets are NOT worksafe and may contain SPOILERS.


01.



__________________________________________________



02.



__________________________________________________



03.



__________________________________________________



04.



__________________________________________________



05.



__________________________________________________



06.



__________________________________________________



07.
















Notes:

Secrets Left to Post: 02 pages, 29 secrets from Secret Submission Post #910.
Secrets Not Posted: [ 0 - broken links ], [ 0 - not!secrets ], [ 0 - not!fandom ], [ 0 - too big ], [ 0 - repeat ].
Current Secret Submissions Post: here.
Suggestions, comments, and concerns should go here.

Comments

Re: What is everyone up to this terrible Monday?

[(Anonymous)]

Put more work in on an electronics kit I'd had lying around. One LED got soldered a bit higher than the others-- it works and doesn't interfere with the case, but it looks goofy.

I'm trying to think of the best way to stabilize the board so I can desolder the connection and push the LED into place.

Re: What is everyone up to this terrible Monday?

[(Anonymous)]

Turns out after desoldering to get most of the solder off, a hot air gun to heat the stuff that flowed into the board holes + applied iron heat + pushing gently down = success! (But hot and uncomfortable in this weather.) Then re-apply solder to secure the component.