Case (
case) wrote in
fandomsecrets2014-01-20 06:34 pm
[ SECRET POST #2575 ]
⌈ Secret Post #2575 ⌋
Warning: Some secrets are NOT worksafe and may contain SPOILERS.
01.

__________________________________________________
02.

[Sleepy Hollow]
__________________________________________________
03.

[Aneurin Barnard]
__________________________________________________
04.

[Trailer Park Boys]
__________________________________________________
05.

[Orphan Black]
__________________________________________________
06.

[Sherlock (BBC)]
__________________________________________________
07.

[Agents of SHIELD, Torchwood]
__________________________________________________
08.

[Saiyuki]
__________________________________________________
09.

[Blake's 7]
__________________________________________________
10.

[The L Word]
Notes:
Secrets Left to Post: 01 pages, 050 secrets from Secret Submission Post #368.
Secrets Not Posted: [ 1 - broken links ], [ 0 - not!secrets ], [ 0 - not!fandom ], [ 0 - too big ], [ 0 - repeat ].
Current Secret Submissions Post: here.
Suggestions, comments, and concerns should go here.

Re: Tech Woes
Today, the replacement bulb arrived via UPS, and although it had taken me all of about five minutes to open up the back and see how it all worked yesterday in anticipation of the arrival, and I figured all I'd need to do is slide the old cartridge out and slide the new one in...
HOUR AND A HALF LATER, I figured out why it wasn't working. Basically there were two problems. 1, the cartridge (being a knockoff) didn't fit in the slot as easily as the official lamp (which cost about $100 more, so NOPE). 2, the "captive thumbscrews" in the new cartridge were, unlike the captive thumbscrews in the old lamp, neither captive or thumbscrews, and also the holes they fit into were too large and they themselves were short.
I figured out #2 almost immediately, but didn't realize that #1 was also a factor until after about an hour and fifteen minutes, when I got frustrated and took the old cartridge and tried putting it back in to see if there was something I was missing, and realized it went about a centimeter further in than I'd managed to get the new cartridge in. So ten minutes of shoving and wiggling and pushing later, I finally got it in as far... and the screws STILL didn't fit and wouldn't go in.
TV turns on anyway, and an hour and a half of basically hanging upside down behind a huge TV with my head squashed against the wall trying to get a clear view of the interior made my head and stomach hate me, so I'm calling it a victory. But ugh, I was planning on going out to run errands afterwards but felt too awful.
(Now I'm starting to feel better, and debating going out vs. actually watching Sleepy Hollow, since I never have had the chance before, and stuff I've seen about it here makes me think I might like it.)
Re: Tech Woes
Re: Tech Woes
Either way, all it is is opening the back panel with a screwdriver, unscrewing a box that holds a light bulb and a filter, pulling it straight out, then putting a new box/light bulb/filter straight in, tightening screws (apparently optional, since I couldn't do it), and putting the panel back on. The only reason it was difficult in this case was because the cheap replacement didn't fit as well as the manufacturer's brand, and I didn't realize for awhile that the fit was as poor as it really was.
Well also it was difficult because it's a 60 inch TV on a narrow entertainment center up against a wall, and I had to get behind it. :P